Deutz-Fahr Agrocompact F60, 70F3, 70F4, F80, F90 service schedule

1. Grease the rear half-shaft bearings and the steering cylinder pin.
2. 2WD: grease the axle oscillation bushes and the steering pins. 4WD: grease the front axle pivot.
3. Wipe off surplus grease.

Tools: Grease gun, Rag

1. Warm the engine, stop it and put the tray under the sump. Take out the dipstick and remove the drain plug.
2. Let the oil drain fully, then refit the plug (new washer if worn).
3. Unscrew the old filter, wipe the sealing face, oil the new seal and screw the filter on by hand.
4. Fill to the top mark on the dipstick, run the engine for a few minutes, stop it and check for leaks, then recheck the level.

Tools: Drain tray (15 L), Filter wrench, Funnel

1. Every 50 hours open the drain on the bottom of the filter bowl until clean fuel with no water comes out.
2. At the change interval unscrew the old cartridge, wet the seal of the new one with diesel and fit it.
3. Bleed air from the fuel system with the hand primer until fuel runs without bubbles, then start and check for leaks.

Tools: Container, Rag

1. Clean round the filter on the right of the gearbox and put a container under it.
2. Unscrew the cartridge and fit a new one with a lightly oiled seal.
3. Start the engine, check for leaks and check the gearbox oil level. The filter lamp may stay on briefly when the oil is cold.

Tools: Filter wrench, Container, Rag

1. Book the tractor in at 600 hours for the valve clearance (0.30 mm cold) and injector cleaning.
2. At 1,200 hours have the injection pump and the alternator checked too.

Tools: Deutz-Fahr workshop

1. Warm the oil, put the tray under the gearbox, take out the plug under the box and drain.
2. Refit the plug and fill through the hole above the lift housing until the round sight glass at the back of the gearbox shows full.
3. Check the level with the engine idling and the lifts fully down.

Tools: Drain tray (50 L), Spanners, Clean funnel

1. Drain the differential and reducer hubs and refit the plugs.
2. Fill each to the lower edge of its level hole.

Tools: Drain tray, Spanners

1. With the engine cold, open the radiator drain cock and expansion tank cap (release pressure slowly) and drain the system.
2. Close the drain, refill with the new mix, run the engine for a few minutes and top up once it has cooled to the middle of the expansion tank.

Tools: Drain tray (15 L), Funnel

1. When the lamp comes on, release the cover and take out the main cartridge. Never run without the safety cartridge.
2. Blow it clean from the inside out with dry air and hold it to a light to check for splits.
3. Fit a new main cartridge once a year or after 6 cleanings, and a new safety cartridge after 3 cleanings. Check the dust valve and the hoses.

Tools: Compressed air (dry, low pressure), Clean cloth