Deutz-Fahr 5105 / 5115 / 5125 service schedule

1. Park on level ground, stop the engine, set the parking brake and take the key out. Run the engine to warm the oil, then let it settle for a few minutes. Hot oil burns, so wear gloves.
2. Put the drain tray under the sump, remove the drain plug and let the oil drain fully.
3. Unscrew the old oil filter, wipe the seat, oil the new filter's seal lightly and fit it. Tighten by hand as the filter says.
4. Refit the drain plug with a clean washer, then fill with oil up to the top mark on the dipstick.
5. Run the engine for a minute, stop it, wait a minute and recheck the level and look for leaks.
6. Take the old oil to a proper disposal point.

Tools: Drain tray (15 L), Socket set, Oil filter strap wrench, Funnel, Gloves

1. Work the tractor first so the oil is warm. Park level, engine off, key out.
2. Drain the oil, change the filters as the handbook shows and refill to the mark.
3. Run the engine, cycle the hydraulics, stop and recheck the level.

Tools: Drain tray (60 L), Socket set, Funnel and filler pump

1. Park on level ground, engine off, key out.
2. Turn each hub until the plug is at the bottom and drain it. Drain the front differential too.
3. Refit the drain plugs, then turn each hub so the level plug is horizontal and fill to the lip of that hole.
4. Refill the differential to its level plug, refit all plugs with clean seals and check for leaks.

Tools: Drain tray, Socket set, Oil pump or filler bottle, Gloves

1. Work on a cold engine only. Never open the radiator cap when hot.
2. Drain the system, flush it with clean water and refit the drain.
3. Refill with the coolant mixture the handbook specifies, run to temperature, let it cool and top up.
4. Coolant is poisonous to animals, so dispose of it properly.

Tools: Drain tray, Funnel, Antifreeze tester, Hose clip pliers

1. Check the air filter warning and replace the element when your handbook says.

Tools: Clean cloth