Landini 6C series service schedule

1. Park level, lower implements, stop the engine, take the key out and chock the wheels.
2. Wipe each nipple clean, then grease the points on the handbook's diagram.
3. Wipe off surplus grease so dirt does not stick.

Tools: Grease gun, Rags

1. Park on firm level ground, lower the linkage, loader and implements, stop the engine, take the key out and chock the wheels.
2. Let it stand a few minutes so the oil is warm, not scalding. Wear gloves.
3. Remove the sump plug and let the oil drain fully.
4. Remove the filter, check the old seal came off, and wipe the filter head clean.
5. Oil the new seal and fit the filter hand-tight as marked on it.
6. Refit the plug with a new washer and fill to the full mark on the dipstick.
7. Run the engine for a minute, check for leaks, stop and recheck the level.

Tools: Drain tray (15 L), Filter wrench, Socket for sump plug, Funnel, Rags, Gloves

1. Park on firm level ground, lower implements, stop the engine, take the key out and chock the wheels.
2. Drain the front PTO housing, refit the plug and fill to the level mark.
3. Check for leaks after the next run.

Tools: Drain tray, Spanners, Funnel

1. Park on firm level ground, lower implements and linkage, stop the engine, take the key out and chock the wheels.
2. Let the oil stand until warm, not scalding. Wear gloves.
3. Drain the transmission, change the hydraulic filter with a new seal and refit the plugs.
4. Refill to the level your handbook shows. Do not overfill.
5. Run the engine briefly, stop, wait and recheck the level.

Tools: Large drain tray (70 L), Spanners, Filter wrench, Pump or funnel, Gloves

1. Park on firm level ground, lower implements, stop the engine, take the key out and chock the wheels.
2. Drain the differential and each hub into a tray, refit the plugs and fill to the level plugs.
3. Check for leaks after the next run.

Tools: Drain tray, Spanners or hex key for plugs, Oil pump or squeeze bottle

1. Only work on a cold engine. Ease the cap off slowly to release pressure.
2. Drain the system and flush with clean water.
3. Refill with the correct mix, run to temperature, let it cool and top up.
4. Dispose of old coolant properly. It is poisonous to animals.

Tools: Drain tray (30 L), Hose, Coolant tester

1. Stop the engine, take the key out and chock the wheels. Keep naked flames away.
2. Clean around the filter, drain any water, then remove the old filter.
3. Fit the new filter with a clean, lightly oiled seal.
4. Prime as your handbook describes. Never crack open high-pressure pipes on a common-rail engine.
5. Start the engine, let it idle and check for leaks.

Tools: Container for fuel, Filter wrench, Rags, Gloves

1. Stop the engine and take the key out. Never run it with the element out.
2. Take out the outer element, leaving the inner in place.
3. Wipe out the housing with a damp cloth. Do not blow dirt into the intake.
4. Fit the new element and close the housing.

Tools: Torch, Damp cloth